Nobeltec InSight Radar 2, Руководство по установке

Страница: 72 / 76

66
Nobeltec InSight Radar (IR2)
Installer’s Guide
Once satisfied that the radar is responding, you can terminate the Ping command by
clicking on the X button in the upper right corner (like any other window) or by hitting
the Ctrl and C key together.
If the list does not scroll as above, or gives the message "Hardware error", "Request
timed out" or anything other than "Reply from 192.168.0.1:….", something is wrong
with the connection. Check the following:
1) Verify that the IR2 works with the direct connect mode. This significantly reduces
the possibility of failure in the IR2 Control box and focuses our attention on the
network.
2) The PC and the radar are connected to a router/hub using straight through
cables (hold connectors upside down side-by-side and verify that the color order
is the same on both sides.)
3) The Network Interface Card software is installed correctly.
4) The power is turned on to the radar and has been for at least one full minute.
5) The LED’s on the RJ-45 connector on both the PC and the MDS box are illu-
minated and/or blinking. The left most LED should remain solid, while the other
LED may blink.
6) Verify the IP address and Subnet mask are obtained automatically.
7) If you are uncertain about the PC’s network configuration, please contact the
network administrator or the NIC card provider technical support.
Troubleshooting