Nobeltec InSight Radar 2, Руководство по установке

Страница: 25 / 76

19
Installer’s Guide
Nobeltec InSight Radar (IR2)
Cable #1: Radar Cable - From Radar
The first cable is the one that connects the radar scanner to the Radar Control Box
(MDS-5R or MDS-6R). If this cable is already attached to the Radar Base you can
skip this section.
Remember : This side of Cable #1 is normally supplied already
connected with 2kW models. All other radar models should follow
the instruction listed below.
Connections with IR2-4D (RB715A)
1) Remove the radome cover from the Antenna unit by gently lifting upward to avoid
bumping against the internal aerial. (There are four screws holding it in place.)
2) If necessary, remove the tape securing the antenna.
3) Remove the shield cover located on the backside.
4) Remove the cable clamping plate and rubber ring, pass the cable through
the opening, replace the rubber ring, and clamp the cable to the scanner unit
with screws on the fixing plate. Attach the cable connector to the X1 and X2
connectors on the printed circuit board.
5) Replace the aluminum cover. Lay the cable shield into the channel machined into
the aluminum housing. Be careful that the cable will not get caught between the
main unit and cover.
6) Manually rotate the antenna to ensure that radar wand will not bump up against
or hit the cable.
7) Replace the upper part of the radome, being careful not to bump it against the
antenna. Make sure that the cover is positioned in the correct direction as shown
in Figure 2.10. The upper and lower parts of the radome each have alignment
markings indicating screw positions.
Hardware Installation