Adjustable mounting solutions
S15P / S19P / S21Wx / C‐Series
Product Information
www.noax.com
Page 6 of 14
3095-US-1.2
2.3
Installation of the rubber feet
Caution!
For safety reasons, a table stand with rubber feet attached may only be installed
and used on a horizontal surface.
The following tools are required to install the rubber feet:
D
Allen key, size 4
D
Open end wrench, box wrench or socket wrench, wrench size 8 mm
Note:
The rubber feet should be installed before the Industrial PC is installed.
Installation steps for the rubber feet:
Fig. 6:
Installation material
Fig. 7:
Rubber feet with mounting bolts
Fig. 8:
Rubber feet under table stand
Fig. 9:
Completely attached rubber feet
"
Place a M5 washer over an M5x18mm hexagon socket screw
"
Insert the hexagon socket screw with the washer into the rubber feet (see Fig. 7)
"
Put the screw in the rubber feet from below through the mounting hole in the table
stand (see Fig. 8)
"
Place another M5 washer on the hexagon socket screw and finally screw on a
M5 cap nut (see Fig. 9)
"
Using a size 4 Allen key to hold the screw in place, screw the M5 cap nut on tightly
with an SW 8 socket wrench, box wrench or open end wrench (1.5 Nm torque).