Adjustable mounting solutions
S15P / S19P / S21Wx / C‐Series
Product Information
3095-US-1.2
www.noax.com
Page 11 of 14
4.3
Install the mount on noax Stainless Steel Floor Stand
Caution
!
Make sure the stainless steel floor stand is positioned securely and properly fastened
before installing the mount!
The following tool is required to install the mount on the floor stand:
D
Allen key, size 5
Fig. 20: Mount positioned above the stainless
steel floor stand and cables installed
Fig. 21: Device bracket completely installed
on the stainless steel floor stand
"
If the cables have already been run through the stainless steel floor stand, guide
them through the hole in the bottom of the mount.
"
Position the mount for the stainless steel floor stand on the top of the stainless steel
floor stand. Make sure the hole in the bottom of the mount lines up with the mount
ing hole in the top of the stainless steel floor stand.
"
Use 4x M6x10mm hexagon socket screws and M6 washers to attach the mount
(size 5 Allen key, 7.5 Nm torque).
"
Now attach the Industrial PC to the mount (see chapter 5)
If the position of the Stainless Steel Floor Stand has to be changed, please follow
this steps:
"
Remove connector protection and cables from the noax Industrial PC
"
Remove the Industrial PC from the mounting bracket
"
Remove the top of the Stainless Steel Floor Stand with the mounting bracket
"
Change the position of the Stainless Steel Floor Stand and fasten it again properly
"
Insert the top of the Stainless Steel Floor Stand with the mounting bracket
"
Mount the Industrial PC onto the mount bracket (see chapter 5)
"
Connect the cables to the IPC and mount the connector protection again
Pay attention to the product information for stainless steel floor stand