NMC-WOLLARD MB-4 200-DF, Инструкция по эксплуатации, техническому обслуживанию и запасным частям

Страница: 69 / 321

4. Connect all transmission and engine wir-
ing.
5. Unplug and connect fuel lines to engine.
6. Slide rear hood support and deck plate
into place and secure.
7. Plug harnesses into receptacles in hood
support.
8. Put radiator and shroud into place and
secure. Reconnect coolant hoses to ra-
diator.
9. Put fan and belts back on engine.
10. Return battery to battery holder and re-
connect cables to engine and battery.
11. Replace drain plugs if you haven’t, re-
place filters and fill engine, transmission
and radiator with proper fluids.
12. Place gear shift lever in neutral position.
Install gear shift cable.
13. Reconnect park brake cable.
14. If unit has not been refilled, fill unit with 4
gallons of recommended lubricant
15. Check for leaks.
16. Start engine and run at idle to let con-
verter and oil lines fill. Check for leaks.
17. With engine at idle, finish filling accord-
ing to 5.5.
5.10 DISASSEMBLY/ASSEMBLY OF
ENGINE TO TRANSMISSION
Consult the supplied Funk Service Manual
for this procedure.
5.11 CALIBRATING THE
SPEEDOMETER
Manual Calibration With a Known Value
(PULSE)
The exact calibration value for the vehicle
and type of sensor you are using
(pulse-per-mile or pulse-per-kilometer) is
31201.3. However, the tenths place is fixed
at 0 and will not be entered during calibra-
tion. The actual calibration value that will be
used during calibration is 31201.
To calibrate your VDO Speedometer
manually:
1. Press and hold in the button on the front
of the speedometer as you turn on the ig-
nition. Hold in the button until the word
“PULSE” is displayed on the LCD read-
out. (See Diagram F)
2. As soon as you see the word “PULSE”,
release the button. After a few seconds,
the display will start flashing a series of
numbers (factory default setting) that
you can change to represent the correct
calibration impulse value (31201). For
example, a number like 50000 will show
on the display, with each digit flashing in
turn, except for the last digit on the right,
which represents the tenths place and is
fixed. First, the second 0 from the right
will flash; then the third 0 from the right;
then, the next 0; and finally, the 5. (See
Diagram H.)
3. As each number flashes, press the but-
ton to change it until the correct digit of
M200 MB4 Tow Tractor Manual No. 42975
PAGE 5-5
JULY 15, 2001