Hub’O: Getting started
All Rights Reserved – nke Watteco®
Hub’O: Description of the exchanges with the Server
Page
9
of
14
3
F
IRST CONFIGURATION
The next step in the Hub’O installation is to correctly configure it. In order to do that, a configuration
file can be filled with the right parameters and can be uploaded on the Hub’O Gateway thanks to one
of its USB slot (cf. Figure 3).
Here below, can be seen the steps to correctly create a configuration file and upload it to the Hub’O
gateway.
3.1
C
ONFIGURATION THROUGH EMBEDED
HUB’O
W
EB
S
ERVER
Form version 2.04 of Hub’O Firmware, an embeded WebServer allows reading and writing the 3 main
configuration objects: GENERAL CONFIGURATION, ALLOWED END-DEVICES LIST, and MODBUS
PARAMETERS.
HUB’O Webserver can be used through Ethernet Local Area Network. Using factory configuration of
Hub’O, it will try to connect through a DHCP server on your LAN. You can set it to static with specific
address through USB File Transfer with “general configuration file (c_01_xxxx.json)” (Cf §3.2).
In any case, you can find current HUB’O IPv4 address (x.x.x.x), on the sixth screen of HUB’O LCD
screen, thanks to successive press on button on the right of the screen. Then the URL to type is
. You will have to connect with following credentials:
-
user / 1234
: Allows read and write of configurations
Содержание Hub'O
Страница 1: ...HUB O GETTING STARTED ...