NK Medical Products, Inc.
Page 4
Rev 2 / 2009
GENERAL INFORMATION
♦
The assembly of a crib will require two people.
♦
The exterior of the crib is protected with one of three corrosion resistant finishes. Available finishes are: Powder Coated Epoxy
(Prefix E), Chrome (Prefix C) and Stainless Steel (Prefix S)
♦
Complete and return the product warranty card to
NK Medical Products, Inc.
Include the serial number which is located at the foot
of the crib.
♦
The illustrations and instructions in this manual encompass the Klimer Crib Assembly. If you have purchased a standard crib, follow
the same instructions EXCEPT skip Step #4 for the curtain assembly.
TOOLS REQUIRED
⇒
Rubber headed mallet (2 pound size)
⇒
Phillips Head screwdriver (medium size)
⇒
Hexagon key wrench (7/64”)
ASSEMBLY INSTRUCTIONS
Step #1
Carefully unpack crib and use parts list to identify all crib components. Insert crib casters stems into crib end sockets
(brake casters in right leg and swivels in left leg) Engage locking caster. Lean end with the serial number facing out at
a slight angle. Two persons will pick up the deck and slip into lock pins and taper lock slot. Once the pins are in,
slightly tap down with the rubber head mallet to secure the pin location. Refer to Figure #1.
Head End
Deck
Lock Pins & Taper Lock
Slot (See Fig #2)
End Frame
Foot End
Serial # Facing Out
Crank Handles
(Gatch Deck Option)
Figure #1
Figure #2
Corner Lock
Pins
End Frame
Deck
Taper Lock Slots
End Post
Caster
Socket
5” Caster
