NK Medical Products, Inc.
Page 5
Rev 2 / 2009
ASSEMBLY INSTRUCTIONS (Cont.)
Step #2
Repeat Step #1 with regard to the lock pins and taper lock slot for the opposite end. This will be the
head end of the crib. IMPORTANT: You will now have the crank end (on the gatch deck option) at the
foot end of the crib. Make sure all lock pins are secure in the taper lock slots. Use the rubber mallet to
drive the lock pins into the taper lock slots. Hit the mallet on each corner of the gatch directly above the
pins. At least two heavy mallet blows will be required to lock the pins into the taper lock slots. The crib
assembly now looks like Figure #3.
Step #3
Working one side at a time, insert the slide tube (squared end first) through the top end of side gate.
Squeeze side gate handle and position gate at lowest holes in slide tube. Install washer (concave
down), rubber bushing, washer (concave up) over squared bottom end of slide rod and insert into bot-
tom guide brackets. Temporarily engage top of slide rod into top end bracket. Check to insure side
gate handles are facing out. Repeat this step for the second side.
Step #4
To install side curtains on Klimer cribs follow this step on both sides of crib. Slide bottom tube of top
side assembly over the top of slide rods, followed by curtain straps and finish by snapping top “C” chan-
nel over top of slide rods. Pull “C” channel down and push in to lock full crib side assembly under and
into the Top End Guide Brackets.
End Frame
Head End
NK
Label
Facing Out
Floor
Mallet
Deck
Lock Pins
End Frame
Foot End
Crank Handles
(Gatch Deck Option)
Figure #3
