Nivus NivuFlow 650, Инструкция по эксплуатации

Страница: 61 / 173

Operation start-up
page 61 NF 650 - rev. 01 / 29.06.2020
A shift key can be found at the bottom left of the keypad (Fig. 26-4 no. 3).
• The functions of the shift key are:
ƒ
Upper case
ƒ
Lower case
ƒ
Special characters
ƒ
Digits
• These settings allow individual names (e.g. of the measurement place).
• To
activate this shift key rotate the rotary pushbutton until the shift key is highlighted
black.
 Ü
To
enter
designations such as the measurement place name proceed as follows:
1. Press the rotary pushbutton - on the lower half of the display a virtual keypad
featuring individually selectable letters is indicated.
2. Turn the rotary pushbutton to navigate through the virtual keypad. Characters high-
lighted blue (Fig. 26-4 no. 2) feature dual functions. Holding the button depressed
for approx. 1 sec. switches over to alternative function.
3. Press the rotary pushbutton until the desired character is highlighted black. By
pressing the character is applied to the text box automatically.
4. Repeat this process until the complete text (e.g. name of the measurement place)
is on the display.
26.4 Use/Entry using the numeric keypad
In certain parameters it is possible to enter dimensions or other numeric values. A number field
(analogous to letter block) is indicated in the bottom section of the display if such a parameter
has been selected.
Note
The use of the numeric key pad is explained here once. Later in the manual you will be
prompted to enter dimensions or numerical values following this explanation.
 Ü
Press the rotary pushbutton - a numeric field will appear:
1. Enter the values digit by digit. Proceed the same way as described before in the
keypad section.
When entering the dimensions observe the correct decimal places. The channel
profile dimension e.g. is set to METER per default.
If multiple dimensions shall be entered consecutively (e.g. for rectangular profiles), you can
get to the next dimension by rotating the rotary pushbutton after your former entry has been
confirmed. For the next entry proceed right as described before.
26.5 Revision of parameters
 Ü
Incorrect entry can be deleted letter by letter or digit by digit by pressing the back button:
1. Open the keypad.
2. Turn the rotary pushbutton until you get to the >back arrow< (back button).
3. Press the rotary pushbutton - this will erase the wrong letter or number.
 Ü
Write subsequently until the complete name or dimension appears in the display and
confirm the entry with the right hand function key.
The name of measurement or the numerical value is taken to the main menu and is
displayed there.