Nivetec UNICONT, Инструкция по установке и программированию

Страница: 18 / 24

18 / 24

pdf4012m0600p_06

BKI15ATEX0013X/1
OPERATION OF THE PROGRAMMING KEYS
P
RESSING KEY
(
S
)
OPERATION
E
+ *
(press for minimum 3 sec)
Getting in and out of PROGRAMMING and MEASUREMENT mode (both directions).
(Returning to Measurement mode means saving of the modifications)
or In MEASUREMENT mode input or output current appears on the screen of the 2-wire or 3-wire model respectively
while Parameter address blinking while Parameter value blinking
E
to select parameter address and go to parameter value to save parameter value and return to parameter address
+
Cancel all modifications of the actual programming procedure.
CANCEL will be displayed for warning.
Neglect value modification of the relevant parameter
(if any) and return to the parameter address.
CANCEL will
be displayed
+
Reset all parameter values to default.
LOAD is be displayed for warning
Reset default value of the relevant parameter.
LOAD will be displayed for warning
+
GET VALUE – function for automatic setting of P0 and P1.
Actual/measured value will be offered as the value to be
programmed. After pressing
E
for saving the value,
‘ SET’ message confirms the modification.
To have the next character to the left blinking (to be able to change that character)
/
Modify the blinking digit (increase, decrease, minus sign) or scroll up / down … 8, 9, “–“, 0, 1, 2, …
*Make sure that
E
is pressed first!
Remarks:
Double key pressing is indicated by ‘+’
If, after pressing
E
, blinking does not jump over from the parameter address to the parameter value, then this means that

the parameter is either read-out type, or

the secret code prevents the modification (see P19)
If the modification of the parameter value is not accepted i.e. the parameter value keeps blinking after pressing ENTER
E

the modified value is either out of range, or

the entered code is not valid