Switch Di600 on and while the ready lamp
is on, press the mode select button to
select desired mode. The mode select
button turns to TTL (no light)— Manual
(red)—SD (green)—SF (blue)-----
Wireless TTL slave(Purple) and back to
TTL.
Setting slave flash Di600:
When flash is set to SD or SF mode,
the first lamp of flash power level is
lighten. This lamp shows the 1/32
manual power level. Press the flash
power level select button at to
select different power of 1/16
→
1/8
→
1/4
→
1/2 and Full.
Press the button at marked — to power
downward. The power you selected is
memorized and remains unchanged
untill the unit is switched off.
When the flash is set to Wireless mode,
the power level will be controlled by the
Master flash. Therefore, no setting is
required on Di600.
Set slave flash at any place and direct the flash head as you
desire. Slave sensor may not respond to the master flash in the
extremely bright condition or under the poor sensing situation.
Use the flash stand included. Place Di600 on to the flash stand
which can be placed either on a flat surface, or on the tripod by
the screw.
NOTE
Metal type accessory shoe is not recommended since it may
give electric damage on the electrical contact of the flash
hotshoe.
Green
Blue
Purple
17
