D-F10120 NP-F369 Product Specifications Rev.0.01(Provisional Ver.)
[Quality]
1.
The product supports only control codes and commands authorized in this document.
2.
With such print program that printing and paper feeding movements get interrupted temporarily due to data queuing etc., printing and paper feeding
may jumble on a very first few dots line.
3.
The print may jumble at the first 1-2 dot right after the paper cut action.
4.
DO NOT touch the heating element part of the thermal head, since it could degrade the print quality due to soil.
5. In case of using print papers other than those specified in this document, print quality and lifetime of thermal head may not reach the level
guaranteed by the manufacturer.
6.
DO NOT pull out the paper while the printer is in motion of printing, paper feeding or cutting. When removing the partially cut paper, pull it to either
right or left direction without too much force.
7. Continuous motor running for a long time generates heat and may affect the printer performance. To avoid the case, it is necessary to limit the
continuous motor running time to 6 minutes at maximum with the same interval time for each operation.
8. Motor may produce heat by continuously driving cutter motor for a long time and it may not perform necessary functions. Make sure to follow cutter
tolerable frequency.
9. Set the paper straightened with no slack.
10. A part of this product is made from coated steel plate. It does not affect the product’s quality and performance at all even if the cut face of the steel
plate get rusty after a long time period.
11. There is a possibility that huskiness occurs in a printing side on this printer because of its structure.
