2) Setting paper by auto-loading function.
①
Set roll paper to paper holder following the above 1) method.
②
Insert paper edge into paper entrance.
(Make sure roll paper will be inserted straightly matching the paper with a paper insertion
guide.)
(When the edge of the paper has tape, cut straightly the paper at right with scissors etc to
signature to peel off the tape.)
③
Paper sensor will detect and the paper is automatically pulled in.
(Make sure thermal head cover is closed.)
(Switch ON in advance)
④
Paper will be pulled in for constant length and cut, and then it will be ready for printing.
Paper insertion slot
【
Caution
】
・
Remove the old core before setting new roll paper.
・
Set paper correctly without winding slack. (It causes paper jam).
・
Leading end of paper must be straight and right angle. (Refer to Figure of paper tip shape)
・
If the broken or slant cut edge of paper is tried to insert, pull-in movement may faile.
・
If there is a tape at the edge of the paper, cut straightly the paper right to the signature of peeling
off tape from taping.
・
Printing must be external side and keep print surface up to insert.
・
When paper inserted at a slant, open the head cover with lever and straighten it.
（
Do not give excessive force beyond the stop position. Pay attention not to catch finger or hand.
）
・
Since thermal head may be highly-heated right after printing, beware not to touch it.
Paper tip shape
D-F10120 NP-F369 Product Spec Rev.0.01(Provisional Ver.)
31
