NINER ENCYCLOPEDIA
>>
SPECIFICATION & SETUP GUIDE
37
: Updated: SEPT 5, 2012
AIR 9 CARBON CABLE ROUTING (GORE CABLES, CONT.)
F11
INSTRUCTIONS - GORE
Front Derailleur:
1) CREATE A CABLE GUIDE - Repeat the process used to install the rear
liner by inserting a shift cable through the bottom bracket until it can be
pulled out through the headbadge (F6).
2) INSTALL THE LINER - Install the correct washer or cable housing ferrule
on the liner according to your head badge type (F1 or F2 - see diagram on
previous page). Slide the liner over the guide cable (F7) until it comes out
of the bottom bracket (F8). Gently pull the liner down until it seats in the
headbadge and remove the guide cable.
3) INSTALLING THE CABLE - Trim 4mm shifter housing to correct length
from the shifter to the opposite hole in the head badge (F9). Route GORE
shifter cable from the shifter through the cable housing into the liner at the
head tube badge, pushing the cable all the way through the liner.
4) RUN LINER THROUGH THE GUIDE - Thread the GORE cable/liner through
the guide tube until it comes out of the seat tube exit hole. Be extra care-
ful not to kink the GORE liner during this procedure (F11).
5) INSTALL SEAL - Push the rubber accordion seal onto the guide tube over
the shifter cable. Install front derailleur.
You can now cable your derailleurs and adjust your system for perfect shift-
ing! Drink your favorite beer in celebration and maybe give your frame a
quick polish for tomorrow’s ride.
