Nimbus Water Systems CS-3, Руководство пользователя

Страница: 10 / 11

10 41840-A McAlby Court, Murrieta, CA 92562
(800) 451-9343, www.nimbuswater.com
Desalinator Replacement
1. Close the feed water shut-o ff valve and close the tank shut-o ff valve.
2. Open the dispensing faucet to relieve system pressure. Close dis-
pensing faucet when fl ow has stopped.
3. Remove old desalinator from clips on frame. Install new desalinator
on frame.
4. Remove feed tubing from old desalinator and insert it in the (green)
feed connector of the new desalinator. See Figure 6.
5. Repeat tube removal and replacement steps for product and drain
tubes.
6. Turn on feed water shut-o ff valve and open dispensing faucet.
7. Close dispensing faucet a ft er water starts running.
8. Observe system for any leaks, especially at newly re placed cartridge.
9. Open the tank shut-o ff valve.
10. The system should be fl ushed at least once as described above under
Sec ti on 8.
Filter Replacement
1. Close the feed water shut-o ff valve and close the tank shut-o ff valve.
2. Open the dispensing faucet to relieve system pressure. Close dis-
pensing faucet when fl ow has stopped.
3. Remove the pre fi lter housing by turning it clockwise (when viewed
from above). Remove old pre fi lter from housing and discard. Remove
O-ring from top of housing. Wash O-ring and housing. Replace O-ring in
groove at top of housing. Insert new
fi lter. Replace housing into cap by
turning counter clockwise. (When viewed from above).
4. Repeat Step 5 for pos tf ilter.
5. Turn on the feed water valve and open the tank shut-o ff valve.
6. Observe system for any leaks, especially at newly re placed cartridge.
7. The system should be fl ushed at least once as described in System
Ac ti va ti on and Flushing.
CS-3 Maintenance
To Drain
(Yellow Collet)
Fig. 6
Feed
(Green Collet)
Product
(Blue Collet)