Nimbus Water Systems CS-3, Руководство пользователя

Страница: 8 / 11

8 41840-A McAlby Court, Murrieta, CA 92562
(800) 451-9343, www.nimbuswater.com
System Ac ti va ti on and Inspec ti on
1. Check all tubing connec ti ons to ensure they are fi rmly seated and secure.
2. Open the dispensing faucet at the sink. Close the tank shut-o ff valve.
3. Open the feed water valve to the system. Observe all tubing and connec ti ons for several minutes to detect any leaks.
In approximately 5 minutes, (assuming normal feed water pressure) the dispensing faucet should begin dripping.
4. Place a pan or other tempo rary water basin near the drain 'P' trap. Loosen the connector nut holding the 3/8" tube
in the drain saddle connec tor. Pull the tube out of the connector and use the pan to catch any water that may spill. Brine
water should be
fl owing from the tube. Reconnect the tube to the drain saddle and hand- ti ght en the connector nut.
5. Allow the faucet the run for up to 15 minutes, then close the faucet.
6. Check for leaks at all connec ti ons.
7. Open the tank shut-o ff valve.
Ini ti al Flushing Procedure
1. Before the system can be used for drinking water produc ti on it must be adequately fl ushed. Each reservoir tank is
dosed with a small amount of powdered sani ti zer before shipment, typically a chlorina ti ng agent, in order to ensure tank
internal cleanliness. Also, the carbon fi lter cartridge will release a small amount of carbon fi nes during the fi rst tankful of
fl ow. This fl ushing procedure will allow any sani ti zer or carbon fi nes to pass from the system.
2. Ini ti al tank fi lling will take approximately one hour (based on average feed pressure). When the tank is full, the water
pressure will have risen to the point where the automa ti c shut-o ff valve inside the system will stop the feed fl ow through
the system. Actua ti on of the automa ti c shut-o ff valve can be determined by either checking for a lack of brine fl ow to the
drain saddle, or by listening very closely near the dispensing faucet for absence of water fl ow sound though the air gap.
When the tank has fi lled for the fi rst ti me, it should be le ft undisturbed for at least 8 hours to ensure proper sani ti za ti on.
3. A ft er 8 hours has elapsed, open the dispensing faucet fully and allow the product water to run out to drain at maximum
fl ow. The ini ti al discharge will be dark with the bulk of the carbon par ti cle wash out. There may also be the scent of chlo-
rinated water from the sani ti zing agent. When the fl ow has diminished to a fast drip or small stream, close the dispensing
faucet.
4. Fill and fl ush the tank at least three ti mes prior to use. If necessary, repeat un ti l the chlorina ti on scent has disappeared.
It is important that the fl ush be done at maximum fl ow (e.g. the tank must be full) to assist in rapid wash out. A ft er this
fl ushing procedure the system is ready for normal use.
Ac ti va ti on and Flushing