7
EN
GEAR
SYSTEM
The rear wheel is fitted with Shimano 6-speed gear (dérailleur) shifter.
Its use is identical to the use of traditional bicycle gearing and it is
governed by the classic lever located near the right-hand handlebar.
AS FOR TRADITIONAL BICYCLE GEARING, IT MUST BE USED WITH THE
BICYCLE IN MOTION.
FRONT
LIGHT
DOC E-BIKE X5 is equipped with a front LED
light.
It is turned on and off from the multi-purpose
display.
PEDAL
ASSIST
(PAS)
CONTROL
PANEL
The pedal assist (PAS) control unit is located on the left side of the handlebar.
On/Off
Battery level indicator
Three-speed PAS mode
DOC X5 is fitted with switches for pedal assist at three speeds.
THE PEDAL ASSIST FUNCTION CANNOT BE ACTIVATED WITH THE BICYCLE AT A STANDSTILL.
PAS operation:
•
Pedal and simultaneously activate the PAS. This method entails a greater use of current and a
greater wear of the motor.
•
Pedal until you create a certain inertia for the bicycle, activate the PAS and resume pedalling.
This method on the other hand allows greater savings in current and therefore a greater
protection of the motor.
•
Cycle while avoiding sudden speed changes; after braking resume pedalling prior to changing
the PAS setting.
•
Do not vary the PAS speed during braking, as this would lead to a motor overload.
•
The current regulator automatically cuts off the electricity supply in the event of overvoltage,
re-establishing it when the electrical load is restored.
•
Do not use the PAS in the rain or on excessively uneven ground.
•
Turn off the PAS before stopping DOC E-BIKE X5, the last few pedal strokes should therefore
be made without electrical assistance.
