Nilfisk-Advance SW900, Руководство по обслуживанию

Страница: 129 / 137

Side Broom System 129 Service Manual – SW900
Side Broom Microswitch Adjustment and Removal/Installation (Continues)
7 Lift the side broom until the end of stroke by
using the lever In this condition check that the
side broom supporting arm (D) is lifted up to the
end of stroke: The bottom of the slot (E) must be
flush with the sliding pin (F).
If necessary, adjust the end-of-stroke with the
nut and locknut (G) of the control cable (L)
8 In the condition indicated by the previous step,
loosen the screws with the nut (H) and lower
the microswitch (I) until its terminal (J) on the
vane (L) is activated; the terminal (J) must also
slightly bend the vane (L) downwards In this
condition tighten the screws with the nut (H) of
the microswitch
Disassembly
9 If necessary, disconnect the electrical
connections (K), remove the screws with the nut
(H), and then remove the microswitch (I).
Assembly
10 Install the microswitch (I) and connect the
electrical connections (K) then loosely install the
screws with the nut (H)
11 Adjust the microswitch (I) as shown in the
previous steps 7 and 8
12 Perform steps 3 to 6 in the reverse order
P200353