Nilfisk-Advance SW900, Руководство по обслуживанию

Страница: 57 / 137

Electrical and Control System 57 Service Manual – SW900
Machine Check/Setting
1 Drive the machine on a level floor and ensure
that it cannot move
2 Turn the ignition key to “0”
3 Remove the hopper by using its transport handle
and wheels
4 Disengage the front fastener and open the
battery compartment hood
5 Disconnect the battery connector
6 Check the battery cables for insulation
7 Remove the battery charger cable (A) from the
housing; connect it temporarily to the electrical
mains and, during the connection, check the
number and color of the LED flashings (B),
then compare them with the indications in the
following table, to determine the battery setting
of the machine
Type of battery set on
the machine
Flashes
EXIDE™ Two flashes of the yellow LED
OPTIMA™
Two flashes of the green and yellow
LEDs together
DISCOVER™
Two flashes of the red and green LEDs
together
GEL/AGM (generic) Two flashes of the green LED
WET (all makes) Two flashes of the red LED
8 If it is necessary to install batteries which are
different from the machine setting, it is possible
to change the machine settings according to the
following procedure
9 If equipped, remove the batteries from the
machine and also remove the battery case
P200314