Nilfisk-Advance Advance Retriever 2060, Руководство по обслуживанию

Страница: 99 / 165

Form No. 56040718 (page 2 of 7)
1.80 “
3.25 “
11.75 “
ø . 406 “ (10.3 mm)
1
Right Side
Hopper Panel
Gearmotor Hanger
Bracket
(on some machines)
FIGURE 2
4 See Figure 2. Raise hopper cover and support. Raise shaker assembly and support.
5 Remove dust control filter.
6 Remove the (11) screws that secure Access Panel (1) in place, then take out the access panel.
7 Check to see if a Gearmotor Hanger Bracket is welded inside of the hopper (at the location shown above) if there is, the Gearmotor Bracket (14)
can be discarded and you can go to step 8. If there is not a welded bracket inside the hopper, drill two .406” (10.3mm) diameter holes at the
locations shown. These holes are for mounting the Gearmotor Bracket (14).
8 See Figure 2. Remove Right Side Hopper Panel (7) screws.
9 See Figure 3. Remove Cover (2) inside the hopper, secured with (3) screws and discard.
10 See the left balloon of Figure 4. If not pre-existing, drill a .76” (19.3mm) diameter hole for wiring at the location shown. Fasten one Strain Relief
(H) into this hole to protect the wiring. Fasten the second Strain Relief (H) into the existing hole in the front of the cab, where actuator wiring will
pass through.
11 If necessary drill (two) .172” (4.4mm) holes for mounting Switch (3), as shown in the right balloon of Figure 4.
Revised 11/00