Nilfisk-Advance Advance Retriever 2060, Руководство по обслуживанию

Страница: 85 / 165

(page 2)
4/99 Form No. 56040695
FIGURE 2
FRONT
A
B
J
3 See Figure 2. Mount the Back Up Alarm (A) as
shown with the (2) (B) Screws from the kit.
4 Directly above this location, hanging from the wir-
ing harness is a wiring connector with a WHT/VIO
wire connected to it, remove the “Dummy” plug
from this connector.
5 Plug Wire Assembly (E) into this connector and
connect the other end to the Positive terminal on
the Back Up Alarm.
6 In the location designated, there is a Screw (J) to
hold ground wires. Remove this screw and re-
attach with Wire Assembly
(D) , connect the other
end to the Negative terminal on the Back Up Alarm.
7 Re-install the Control Panel.
8 Open the large Left Side Access Door.
9 See Figure 3. Install the Switch (F) as shown using
the (H) Screws, (C) Washers and Nut Plate (G) .
10 With the drive pedal in the neutral position, the
roller on the switch actuator should be just to the
left of the Pump Arm
(K) .
11 To the right of the switch, at the rear of the engine,
there is a wiring connector with a GRA/RED and a
WHT/VIO wire connected to it. Remove the
“Dummy” plug from this connector and plug the
Switch
(F) into it.
12 Re-connect the battery and close the Access Door.
13 Test the Back Up Alarm for proper operation, it
should sound when the machine is in reverse.
FRONT
F
C
H
G
K
FIGURE 3