64
- FORM NO. 56043115 - 34 RST
Wheel Drive System
Drive Motor Transaxle Removal (continued)
Service Note
: You may find it easier to loosen the wheel Nuts
(A)
slightly when the wheels are still on the ground
and before you jack up the machine.
5. See Figure 5.
Jack the front of the machine from this location until the drive wheels are approximately 1” off
the ground.
6. Remove the (6) wheel Nuts
(A)
and remove the (2) Drive Wheels
(B)
from the Motor Transaxle
(D)
.
7. Disconnect the drive motor wiring connector.
8. Remove the (4) Motor Mount Bolts and Nuts
(C)
, and the two Transaxle Mount Plates
(E)
and carefully slide
the Motor Transaxle
(D)
away from the machine.
9. Reinstall the Motor Transaxle
(D)
by following the above steps in reverse order. Note that the tapered ends of
the wheel Nuts
(A)
go against the Drive Wheels
(B)
.
FIGURE 5
