77
- FORM NO. 56043115 - 34 RST
Electrical System
6
7
9
5
8
10.
Remove the dust cap
(6)
from the top of the gear housing
(5)
using your fingers or a small screw driver.
11. Place a 1/2” socket
(9)
over the limit adjustment nut
(7)
to turn the nut, and increase or decrease the lower limit
as follows:
•
Important:
Even though the center of the adjustment nut looks like it
will accept a screwdriver blade, this is the retainer for the adjustment
nut.
Do Not try to turn the retainer!
• Each “click” of the adjuster nut changes the Housing Distance by 1/16”.
• To increase the Housing Distance, turn the nut clockwise.
• To decrease the Housing Distance, turn the nut counterclockwise.
• If you need to make large adjustments, it is recommended to move the
actuator away from its limit position first.
12. To check your adjustments, you must first raise the actuator away from
the limit position before lowering it back to the limit position and re-
measuring the Housing Distance for the Lower Limit.
13. After adjusting the Lower Limit, it is a good practice to confirm both
limits by cycling the actuator to the upper and then lower limit.
14.
Before disconnecting the Adapter cord
(1)
, lower the lift actuator down to the scrub deck to make it easier to
reinsert the link pin
(3)
and retaining key
(2)
.
15.
Reassemble the machine.
Do Not
Turn!
Turn Outer
Nut Only
