Niles A4.6Ci, Руководство по установке и эксплуатации

Страница: 96 / 107

96
STEPS TO ERASE MASTER-KEY SEQUENCES
To erase Master-Key Sequences, follow the same steps as if you were going to build the sequences, up to when
you identify the page and key address where the individual commands are stored. Instead, press the PRO-
GRAM key to erase the sequence and exit.
Step 1
-
Press the PROGRAM button once, then the NEXT button three times. The (POWER)/MASTER KEY
SEQ LED turns on GREEN.
Step 2
-
Press a Master Key or press the OFF Key.
The TRIGGER LED turns off, and the PAGE LED continues to blink RED.
Step 3
-
Press the PROGRAM button. The TRIGGER LED turns on RED, and the PAGE LED blinks RED.
At this point, the Master-Key Sequence is automatically erased.
Step 4
-
Repeat step 2 and step 3 to erase other Master-Key Sequences.
or
Press the PROGRAM button again to exit.
STEPS TO ERASE ZONE AND SYSTEM ON/OFF SEQUENCES
To erase Zone and System ON/OFF sequences, follow the same steps as if you were going to build the
sequences, up to when you identify the page and key address where the individual commands are stored.
Instead, press the PROGRAM key to erase the sequence and exit.
Step 1
-
Press the PROGRAM button once, then the NEXT button four times. The (INPUT)/ZONE SEQ LED
turns on GREEN, the TRIGGER LED turns on RED, and the PAGE LED blinks RED.
Step 2
-
The Zone 1 LED blinks, to indicate that Zone 1 is selected by default. The LEDs for the remaining
zones are off. To erase a Zone Sequence for a zone other than Zone 1, press the Zone Select button until
the LED for the desired zone/system blinks GREEN.
Step 3
-
Press the ZONE ON button to erase the Zone/System On Sequence for that zone. The INPUT 1
LED turns on.
or
Press the ZONE OFF button to erase the Zone/System Off Sequence for that zone. The INPUT 4 LED turns on.
The selected zone's LED stops blinking and turns on solid GREEN. The TRIGGER LED turns off and the
PAGE LED blinks RED.
Step 4
-
Press the PROGRAM button. The TRIGGER LED turns on RED, and the PAGE LED blinks RED.
At this point the Zone/System Sequence is erased.
Step 5
-
Repeat steps 2 through 4 to erase other Zone and System On/Off sequences for the same zone or
for different zones
or
Press PROGRAM again to exit.
PROGRAM-EDITING STEPS