
After use
38
After use
After wet vacuuming
WARNING!
Carry out the following steps as soon as you stop vacuuming.
Never leave the appliance unattended.
Press the ON/OFF switch to switch off the appliance.
Remove the plug from the mains socket.
Wind the power cord around the cable holder of the appli-
ance.
Empty, clean and dry the canister.
Emptying and cleaning of
the canister
WARNING!
Before conducting any maintenance or cleaning, switch off and
unplug the appliance. If the mains plug is plugged in, the appli-
ance could accidentally be switched on, resulting in injuries.
Release both canister clips and remove motor head from the
canister by means of the carrying handle and set on side.
Empty
the
canister.
ATTENTION!
Dispose dirt water and cleaning agents in accordance with the
applicable environmental regulations in your country. If possible,
treat and recycle.
Check the filters and clean or replace them if necessary.
After wet vacuuming, thoroughly dry the interior of the appli-
ance and any wet accessories (nozzles, suction hose, suction
tubes, etc.) and only then install the desired filters.
Install motor head on canister and fasten canister
clips.
The appliance, accessories and canister should, however, be
cleaned with a moist cloth when required. When doing this,
take care to ensure that no electrical components come into
contact with water.
Filters
Filters must be cleaned or replaced at certain intervals in order to
obtain the utmost cleaning efficiency from the appliance.
NOTICE!
Use only original Fakir / nilco filters.
Only in this way can the excellent filter effect of the cleaner be
retained.