Operating
37
Wet vacuum cleaning
(only IC 335)
Release both canister clips and remove motor head from the
canister by means of the carrying handle and set on side.
Take off the textile filter.
Remove dust bag and check whether the motor protection
filter / foam filter is inserted correctly.
Put motor head on canister and fasten canister
clips.
Place the desired accessory and switch on the appliance.
ATTENTION!
If the float valve responds prematurely during wet cleaning (ev.
foaming), switch off the appliance and withdraw the mains plug
before cleaning the appliance.
Float valve
When the maximum liquid level in the canister is reached, the
float valve will automatically close the intake aperture in the
motor head, interrupting the cleaning process.
Switch off the appliance immediately and withdraw the mains
plug.
Carry or pull the complete appliance to the disposal point and
empty the canister. See disposal note on the next page.
ATTENTION!
It's absolutely necessary that the motor protection filter / foam
filter is installed over the float valve housing during wet vacuum
cleaning.
NOTICE!
If the appliance falls over during use, the float will cut off the
air flow.
Switch off the appliance immediately.
Return appliance to upright position.
Wait until the motor comes to a standstill and the float valve
returns to its normal position.
The appliance then can be restarted and operations re-
sumed.
ATTENTION!
When vacuuming water with chemical cleaning agents and
heavy dirt it is recommended to use the protective grid* (optional
accessory).
Illustr. similar