Nikon Eclipse Ti-E, Инструкция по эксплуатации

Страница: 56 / 133

Chapter 3 Operation
3.1 Power On/Off
54
3.1 Power On/Off
3.1.1 Power On
B
Coarse
Fine
ExFine
Epi Shutter
FL Block
Refocus
Escape
PFS
OFFSET
OUT
DICHRO
IC MI RROR
IN
L80
EYE
MEMORY
DISPLAY
ON
Z-RESET
1X 1.5X
BRIGHTNESS
R100
L100
FOCUS
PFS
Figure 3-1 Power switch locations
Turn on the dia illumination power supply and the
microscope, as described below.
1. Check that the power supply and the
microscope are connected correctly.
For details on the connection, refer to Chapter 4,
“Assembly.”
2. Check the setting of the EXTERNAL switch
(or the CTRL switch) on the back of the
power supply.
To use the brightness control knob on the
microscope, set the switch to ON. To use the
brightness control knob on the power supply, set
the switch to OFF.
For details, refer to Section 3.2.2, “Power Supply
Setting.”
3. Turn on the power supply by pressing the “I”
side of the POWER switch on the front of the
power supply.
When the power is ON, the POWER indicator
will be lit.
*
On TE-PS30W and TE-PSE30, the POWER
switch has a built-in power indicator.
MIC CONTROL
POWER
OFF ON
LAMP CTRL
DC24V IN
USB
Gepruftes Medizinprodukt
Approved medical device Freiwillige Produktprufung
R
5 3 1 0 0 1
This device complies with Part 15 of the FCC Rules.Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference,and
(2)
EQUIPMENT 4N75
MODEL : Ti-E
INSPECTION TUV Rheinland
Product Safety
JAPAN
this device must accept any interference received, including interference
that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numØrique de la classe A est conforme la norme NMB-003 du Canada.
Figure 3-2 Ti-E (rear view)
4. Turn on the microscope by pressing the
“ON” side of the POWER switch on the back
of the microscope.
Power to the Ti-E or Ti-E/B microscope is
supplied via the AC adapter. Check the
connection of the AC adapter before turning
on the power.
See Chapter 4, “Assembly.”
When the power is turned on, indicator lamps on
the front and the side of the microscope will be
lit, and the system status is displayed on the
status display panel on the front.
3.1.2 Power Off
To turn the microscope off, first turn off the
microscope, and then turn off the dia illumination
power supply.
The microscope can be turned off by pressing the
“OFF” side of the POWER switch on the back of the
microscope body. The power supply can be turned
off by pressing the “O” side of the POWER switch on
the front of the power supply.
POWER
switch
(back side)
POWER
switch
POWER switch DC24V IN connector
(for AC adapter)