First Steps: Putting Batteries in the Camera
14
For more information on:
The batteries can be removed without affecting photographs stored on
the camera’s memory card. All M-REC settings except date and language
will, however, be reset.
The camera’s clock-calendar is powered by a separate rechargeable bat-
tery. When you put batteries in your camera for the first time or after a
long period of storage, wait a few hours for the clock battery to recharge
before removing the main batteries.
Putting Batteries in the Camera
1
Turn the camera off
Turn the mode dial to the off position.
If the camera is on a tripod, remove
the tripod before proceeding to the
next step.
2
Open the battery-chamber cover
Firmly pressing the button in the cen-
ter of the latch, slide the latch to the
open position ( ), then open the bat-
tery-chamber cover as shown at right.
3
Insert the batteries
Insert four LR6 (AA) batteries with the
+ and – poles oriented as shown in
the label inside of the battery-cham-
ber cover.
4
Close and latch the battery-chamber cover
Close the battery-chamber cover and, keeping the cover
held firmly closed by pressing it where labeled “
▼
Push
,”
return the latch to the locked position (
). To prevent the
batteries from falling out of the camera during operation,
confirm that the cover is latched.
5
Check the battery level
Turn the mode dial to A-REC and check the battery level in
the control panel.
Batteries fully charged
Low battery
Replace the batteries as soon as possible.
Batteries exhausted
No photographs can be taken until the batteries
have been replaced.
Battery types approved for use in your camera
Safe storage and handling of batteries
