![background image](http://html1.mh-extra.com/html/niko/1xx-90001/1xx-90001_manual_1689571008.webp)
EN nv
Niko
sa Industriepark West 40, BE-9100 Sint-Niklaas, Belgium — tel. +32 3 778 90 00 — fax +32 3 777 71 20 — e-mail: [email protected] — www.niko.eu
PM1XX-90001R15501
1XX-90001
8
3.
Within 15 seconds, simultaneously press
the
and
keys on the RGB(W) wall
control to be removed for approximately
one second.
The LED strip will flash three times as
confirmation.
4.
Wait 20 seconds before controlling the
LED strip.
6. TROUBLESHOOTING
Problem
Cause
Solution
In a master-slave configuration,
the LED strips have different
colours.
One or more wires between
the RGB(W) controller and the
LED strip are not connected,
have been switched or have
short-circuited.
Correctly connect the wires to
the RGB(W) controller or the
LED strip.
Due to a disruption of the
radio frequency between the
various RGB(W) controllers a
synchronisation moment was
missed (during the red colour).
Press the
key. All
RGB(W) controllers that are
programmed as slaves,
are synchronised with the
RGB(W) controller which is
programmed as the master.
In a master-slave configuration,
the LED strips have a reversed
dimming behaviour.
Due to a disruption of the radio
frequency, the wireless signal
of an RGB(W) wall control is
not being received by one or
more RGB(W) controller(s).
Press the
key for several
seconds until all LED strips
have reached their maximum
light intensity. All LED strips
now have the same dimming
behaviour.
In a master-slave configuration,
the LED strips suddenly
change colour when you select
that colour.
Due to a disruption of the radio
frequency, the wireless signal
of an RGB(W) wall control is
not being received by one or
more RGB(W) controller(s).
Press the
key for several
seconds until you have run
through the entire colour
loop and all LED strips run
synchronously again.
After you have pressed the
key, master and slave have
different colours.
You have added a new RGB(W)
controller, but you forgot to
save a favourite colour.
Press the
key for several
seconds until you have run
through the entire colour
loop and all LED strips run
synchronously again.
Set your favourite colour.
7. WARNINGS REGARDING INSTALLATION
• The installation should be carried out by a registered installer and in compliance with the statutory regulations.
• This user manual should be presented to the user. It should be included in the electrical installation file, and
it should be passed on to any new owners. Additional copies are available on the Niko website or via the Niko
support service.
• During installation, the following should be taken into account (non-exhaustive list):
- the statutory laws, standards and regulations.
- the technology currently available at the time of installation.
- this user manual, which only states general regulations and should therefore be read within the scope of
each specific installation.
- the rules of proper workmanship.
This product complies with all of the relevant European guidelines and regulations. If applicable, you can find the
EC declaration of conformity regarding this product at www.niko.eu.
8. NIKO SUPPORT
In case of doubt or for the specific exchange procedure in case of a possible defect, contact the Niko support
service in Belgium at +32 3 778 90 80 or your wholesaler/installer. Contact details and more information can
be found at www.niko.eu under the “Help and advice” section.
9. GUARANTEE PROVISIONS
• The period of guarantee is four years from the date of delivery. The delivery date is the invoice date of purchase
of the product by the consumer. If there is no invoice, the date of production applies.
• The consumer is obliged to inform Niko in writing about the non-conformity, within two months after stating
the defect.
• In case of a non-conformity, the consumer only has the right to a product repair or replacement free of charge,
which shall be decided by Niko.
• Niko shall not be held liable for a defect or damage resulting from incorrect installation, improper or careless
use, incorrect operation, transformation of the product, maintenance that does not adhere to the maintenance
instructions or an external cause, such as damage due to moisture or overvoltage.
• The compulsory regulations of the national legislation concerning the sale of consumer goods and the
protection of the consumer in the countries where Niko sells, directly or via sister companies, subsidiaries,
chain stores, distributors, agents or permanent sales representatives, take priority over the above-mentioned
rules and regulations.
Do not dump this product with the unsorted waste. Bring it to a recognised waste collection point. Together with producers
and importers, you have an important role to play in the advancement of sorting, recycling and reusing discarded electrical
and electronic appliances. In order to finance the waste collection and processing, the government levies a recycling
contribution in some cases (included in the purchase price of this product).