51
EN
10-845
Press the reset key.
The green LED flashes.
Hold down the reset key until the green LED flashes rapidly.
Release the reset key.
The green LED will light up. Factory settings are loaded.
If many images have to be deleted, it can take several minutes for the factory settings to load.
The yellow LED is on while the images are deleted. As soon as all images have been deleted and the factory settings have been loaded, a
confirmation signal sounds. The yellow LED switches off.
9. OPERATING MODE
Operating mode
Description
EFH mode
• An image is recorded at each door call.
• The images can be seen and removed on any internal unit. The serial number of the internal unit does not matter.
• If no speech connection is established, the images can be viewed via the image and function key.
For privacy reasons, the EFH mode can not be used in multi-family homes.
Basic mode
• An image only appears on the screen with doors calls by preprogrammed serial numbers.
• The images can only be seen/removed on the assigned internal unit.
• If no speech connection is established, the images can be viewed via theimage and function key.
Comfort mode
• An image only appears on the screen with doors calls by known serial numbers.
• The images can only be seen on the assigned internal unit.
• Images are viewed via special protocols. Control information can be found in the manual or the product information of
the internal video unit.
Comfort-simplex mode
• An image is recorded at each door call, regardless of the serial number. The images can be seen on any internal unit.
The serial number of the internal unit does not matter.
• Images are viewed via special protocols.
For privacy reasons, the EFH mode can not be used in multi-family homes.
10. PROGRAMMING VIA IR REMOTE CONTROL
Start programming via IR remote control.
Enter the numbers, the 6-digit serial number (SN) of the 10-845 (=factory setting) as authorisation.
Change the master code using the IR remote control.
Anyone with an IR remote control can execute programming on any device using a preset master code.
For safety reasons the preset master code must be changed when put into service.
Terminate programming.
When entered correctly, a confirmation tone sounds. If the input of a command series is interrupted during 8 seconds, the entire series is
cancelled. A confirmation signal sounds.
If a command series is incompatible with the requested syntax or if too many parameters are entered, the entire command series is cancelled.
A confirmation signal sounds.
When operating the IR remote control, aim the front towards the screen memory as much as possible. The IR remote control has a direct reach
range of max. 1 m. Each push on the key of the IR remote control is confirmed by the screen memory with a short tone.
