background image

Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com

INS-XPP-5420GX/GXA-DL-21

10-13-2021

Instruction Manual

XPP-5420GX & XPP-5420GXA

THE XPP-5420GX/GXA IS APPROVED FOR USE 

CLASS I DIV 1 GRPS A-D T3

CLASS II & III DIV 1 GRPS E-G T135C

CLASS I ZONE 0 IIC T3

CLASS II ZONE 20 IIIC T135C

-20ºC ≤ Tamb ≤ +40ºC

1.5V/Cell AA Alkaline

ID 4003544

INTRINSICALLY SAFE

SECURITE INTRINSEQUE

Bayco Products, Inc.     XPP-5420GX

Wylie, TX 75098

640 S. Sanden Blvd.

CLASS I DIV 1 GRPS A-D T3

CLASS II & III DIV 1 GRPS E-G T135C

CLASS I ZONE 0 AEx ia IIC T3 Ga

CLASS I ZONE 0 Ex ia IIC T3 Ga

Ex ia op is I Ma

Ex ia op is IIC T3 Ga

Intertek ITS 13 ATEX27837X

IECEx ITS 16.0067X

UKEX: ITS21UKEX0264X

-20ºC ≤ Tamb ≤ +40ºC

1.5V/Cell AA Alkaline

2575

ID 4003544

INTRINSICALLY SAFE

SECURITE INTRINSEQUE

I M 1 Ex ia op is I Ma

II 1 G Ex ia op is IIC T3 Ga

Bayco Products, Inc.    XPP-5420GXA

Wylie, TX 75098

640 S. Sanden Blvd.

Conforms to:

ANSI/UL STD 913, ANSI/UL 

60079-0, ANSI/UL 60079-11 

ANSI/ISA 60079-26

Certified to:

CAN/CSA STD C22.2 No 157

CAN/CSA STD C22.2 No 60079-0

CAN/CSA STD C22.2 No 60079-11

CSA STD C22.2 No 25

0359

Ex ia op is I Ma

Ex ia op is IIC T3 Ga

(-20ºC ≤ Tamb ≤ +40ºC)

NCC 15.0286 X

21-AV4BO-0137X

WARNINGS - INTRINSICALLY SAFE

y

Warning: Use only the approved non-rechargeable batteries listed below.

y

Warning: Do NOT attempt to use rechargeable AA batteries with this light.

y

Warning: To prevent ignition of a hazardous atmosphere, do not open the lens bezel in 

the hazardous environment. This task must ONLY be performed in an area known to be 

non-hazardous.

y

Warning: When exchanging batteries, use only Duracell PC1500 or Energizer EN91 

batteries.

y

Warning: To prevent ignition of a hazardous atmosphere, the AA batteries must only be 

exchanged in an area known to be non-hazardous.

y

Warning: To reduce the risk of explosion, do not mix new non-rechargeable batteries 

with used non-rechargeable batteries, or mix non-rechargeable batteries from different 

manufacturers.

y

Warning: Substitution of components may impair intrinsic safety.

SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY

For personal safety, always confi rm the rating of any known hazardous or potentially 

hazardous location where the light is to be used.

BATTERY INSTALLATION

WARNING: In order to maintain the Intrinsically Safe rating, the only AA batteries 

certifi ed for use with this light are the Duracell PC1500 or Energizer EN91 batteries.

y

Do not attempt to use any other brand or model of AA batteries with this light.

y

Do not attempt to use any type of rechargeable AA batteries with this light.

Warning:  To  prevent  ignition  of  a  hazardous  atmosphere,  do  not  remove  the  lens 

bezel or the refl ector / battery carrier in the hazardo us environment. This task must 

ONLY be done in an area known to be non-hazardous.

y

Loosen the locking screw located on the side of the lens cap. NOTE: Do NOT attempt 

to completely remove the locking screw. Doing so is not necessary and may damage the 

threads. The screw simply needs to be loosened enough to allow the lens bezel to unscrew.

y

Unscrew the lens bezel from the housing in a counterclockwise direction.

y

Turn the light upside down and carefully shake the light in order to remove the 

refl ector / battery carrier. Allow the refl ector / battery carrier to slide into your hand. 

WARNING: Do NOT touch the refl ector surface with your fi nger. Doing so may damage 

the refl ector surface.

y

Using 3 – AA Duracell PC1500 or Energizer EN91 batteries (make sure that all 3 

batteries are of the same model), install the batteries in the carrier paying close attention 

to the markings on the battery carrier for proper battery terminal polarity alignment.

y

Align the refl ector / battery carrier so that the switches on the carrier are aligned with 

the switches on the housing. Carefully insert the refl ector / battery carrier back into the 

fl ashlight housing until it is fully seated in the housing. WARNING: Be careful to not touch 

the refl ector surface with your fi nger. Doing so may damage the refl ector surface.

y

Replace the lens bezel by screwing it onto the housing in a clockwise direction.

y

Tighten locking screw. CAUTION: Do NOT over-tighten. Doing so may damage the 

threads and impact the light’s Intrinsic Safety. 

OPERATION 

THE XPP-5420GX/GXA HAS TWO SEPARATE LIGHTING MODES:

MOMENTARY FLASHLIGHT MODE

Lightly press the body switch for momentary operation. Release the switch to turn the 

light off.
CONSTANT-ON FLASHLIGHT MODE

Press the body switch until it clicks and then release for constant-on mode. Press and 

release the body switch again to turn the light off.

WARRANTY

LIMITED LIFETIME WARRANTY

Bayco Products, Inc. warrants this product to be free from defects in workmanship and 

materials for the original purchaser’s lifetime. The Limited Lifetime Warranty includes the 

LEDs, housing and lenses. Rechargeable batteries, chargers, switches, electronics and 

included accessories are warranted for a period of two years with proof of purchase. Normal 

wear and failures which are caused by accidents, misuse, abuse, faulty installation and 

lightning damage are excluded.

We will repair or replace this product should we determine it to be defective. This is the 

only warranty, expressed or implied, including any warranty of merchantability or fi tness for 

a particular purpose.

For a complete copy of the warranty, go to www. baycoproducts.com/bayco-product-

support/warranties. Retain your receipt for proof of purchase.

 Mode  d’emploi

XPP-5420GX & XPP-5420GXA

LA LAMPE DE POCHE A ÉTÉ APPROUVÉE POUR UTILISATION

AVERTISSEMENTS : SÉCURITÉ INTRINSÈQUE

y

Avertissement : Utiliser seulement les piles non rechargeables approuvées et énumérées 

ci-dessous. 

y

Avertissement : NE PAS essayer d’utiliser des piles rechargeables AA avec cette lampe 

de poche.

y

Avertissement  :  Pour  éviter  l’infl ammation  d’atmosphère  dangereuse,  ne  pas  ouvrir 

la lunette avec lentille dans un endroit dangereux. Cette tâche doit être effectuée 

UNIQUEMENT dans une zone non dangereuse.

y

Avertissement : Lorsque vous remplacer les piles, utiliser uniquement les piles Duracell 

PC1500 ou Energizer EN91.

y

Avertissement  :  Pour  éviter  l’infl ammation  d’atmosphère  dangereuse,  les  piles  AA 

doivent être remplacées dans une zone non dangereuse.

y

Avertissement : Pour réduire les risques d’explosion, ne pas mélanger les piles neuves 

non rechargeables avec des piles non rechargeables utilisées, ou mélanger les piles non 

rechargeables de différents fabricants.

y

Avertissement : la substitution de composants peut compromettre la sécurité intrinsèque.

Содержание XPP-5420BA

Страница 1: ... down and carefully shake the light in order to remove the reflector battery carrier Allow the reflector battery carrier to slide into your hand WARNING Do NOT touch the reflector surface with your finger Doing so may damage the reflector surface y Using 3 AA Duracell PC1500 or Energizer EN91 batteries make sure that all 3 batteries are of the same model install the batteries in the carrier paying...

Страница 2: ...ncia Al cambiar las pilas utilice sólo pilas Duracell PC1500 o Energizer EN91 y Advertencia Para evitar la ignición de una atmósfera peligrosa las pilas AA sólo deben cambiarse en un área considerada no peligrosa y Advertencia Para reducir el riesgo de explosión no mezcle pilas nuevas no recargables con baterías no recargables usadas y no mezcle pilas no recargables de diferentes fabricantes y Adv...

Страница 3: ...ustauschen der Batterien verwenden Sie ausschliefllich Duracell PC1500 der Energizer EN91 Batterien y Warnhinweis Um eine Entflammung in einer explosions gefährdeten Atmosphäre zu verhindern tauschen Sie AA Batterien nur in einem Umfeld aus das bekannterweise ungefährlich ist y Warnhinweis Um das Risiko einer Explosion zu vermindern vermeiden Sie es neue nicht wiederaufladbare Batterien mit gebrauc...

Страница 4: ...and technical specifications have been applied and evaluated by Directives ATEX Directive 2014 34 EU UKSI 2016 No 1107 Article 34 of the Industrial Safety and Health Act and Article 58 4 Paragraph 4 of the Enforcement Rule of the same Act Notified Body INTERTEK ITALIA SPA Via Guido Miglioli 2 A 20063 Cernusco sul Naviglio MI Italy INTERTEK TESTING CERTIFICATION LTD Academy Place 1 9 Brook St Brent...

Отзывы: