NIFTYLIFT NL140RKT, Руководство по эксплуатации

Страница: 5 / 43

NIFTY LIFT
OPERATING INSTRUCTIONS
Note: Clear illustrations of the controls of this machine are shown on the pages following this section of
the manual.
Radio Remote Basket
Radio Remote Startup
To activate the radio remote control system:
•
Switch the key switch next to the START button on the transmitter to the ‘O’ position. Ensure that the
battery is in its housing and has enough charge. Check that the STOP button has not been pressed
and that none of the joysticks are activated (out of neutral). Turn the Key switch to the ‘I’ position and
press and hold the START button, releasing on when the green LED starts to flash.
NOTE: Check that the green LED on the turret electrical junction box stating ‘REMOTE
CONTROL ACTIVE’ is ON.
NOTE: The radio remote transmitter will only switch on if there is enough charge in the battery
if all joysticks are inactive.
The remote control system is now ready to operate. Check that all machine functions correspond to the
transmitter functions.
Boom Controls
•
To enable boom controls, the deadman joystick, located at the centre of the transmitter, must be
moved and held either to the left or to the right as indicated.
•
Once the deadman has been activated, the EWP functions; bottom boom lift, top boom lift, tele boom
extension and slew (not necessarily in that order), may be operated by pushing down on the
respective joystick and moving it to the desired function.
NOTE: EWP FUNCTIONS WILL NOT OPERATE UNLESS THE DEADMAN JOYSTICK IS OPERATED
PRIOR TO A FUNCTION JOYSTICK BEING OPERATED.
•
For precise operation of EWP functions, move the FAST/SLOW switch to the SLOW position to
reduce the work platform function speeds.
Hydraulic Power Tools (If fitted)
•
To operate the hydraulic power tools open the ball valve (ON) located on the base control cover prior
to entering the basket.
•
With the DC PUMP/POWER TOOLS switch on the transmitter in the neutral position, connect the
power tools hoses to the quick release couplings located outside the basket.
•
Once the tools are connected, move the DC PUMP/POWER TOOLS switch on the transmitter to the
POWER TOOLS position to allow the flow of hydraulic oil to the power tool.
•
Adjust the speed of the tools using the needle valve, which is located near the quick release
couplings outside the basket.
24.03.19