12
MECHANICAL INSTALLATION
Installation guide Powerdrive MD Smart Equipment
5704 en - 2021.10 / b
The packaging materials used may vary depending on the
type of transport. Here is the list:
Raw material
Method of recycling possible
Plywood or wood chip
Recycling or disposal
Raw wood products
Recycling or disposal
Anti-static film
Recycling or disposal
Heat-shink envelope
Material: Polyester
Recycling or disposal
Strapping
Recycling or disposal
Wrap around carton and
reinforcements
Recycling or disposal
Corner protections
Material: Polyester
Recycling or disposal
Corner protection adhesive
Material: Acrylic co-p
paper
Recycling or disposal
Foam
Material: Polyethylene
Recycling or disposal
2.2 - Checks on receipt
Make sure that the drive cabinet has been
transported vertically, otherwise it could be
damaged.
Before installing the equipment, check that:
- the equipment has not been damaged during transport,
- the information on the nameplate is compatible with the
power supply.
2.3 - Handling
• The centre of gravity could be high up
and/or off-centre, so beware of the risk of the drive
cabinet tipping over.
• Check that the handling equipment is suitable for the
weight to be handled.
• The lifting accessories provided are limited solely to
handling the drive cabinet. If subsequent handling
operations are carried out, always check that these lifting
accessories are in good condition.
Above 2400 mm wide (W), a baseplate 100 mm high is
installed as standard to ensure the rigidity of all the drive
cabinets and for lifting them (if necessary refer to the drawing
of the device supplied in the THxxxxx plan).
2 - MECHANICAL INSTALLATION
• It is the responsibility of the owner or user to
ensure that installation, operation and maintenance
of the equipment and its options comply with legislation
relating to the safety of equipment and personnel, and
with the current regulations in the country of use.
• The equipment must be installed in an environment free
from conducting dust, corrosive fumes, gases and fluids,
and condensation (class 2 according to IEC 664-1). The
cabinet must not be installed near flammable materials.
The equipment must not be installed in hazardous areas
unless it is in an appropriate enclosure. In this case the
installation must be approved.
In atmospheres where condensation can form, install
a heating system (to be switched off when the drive is
operating).
• Prevent access by unauthorized personnel.
RECOMMENDATIONS:
• The cabinet must be fixed to a flat, even floor.
For cabinets equipped with climate control the recommended
flatness tolerance is 4 mm every 2 m.
The floor must be solid enough to withstand the mass of the
electrical equipment.
A minimum distance of 1000 mm must be left for access to the
front face of the cabinet.
• The cabinet is to be located in a well-lit location (200 lux
minimum).
• Each door has a locking system (capable of being opened
using a tool, it must be kept closed with a key).
2.1 - Packaging
There are two possible types of packing:
- SEI4C maritime packaging
- slatted packaging
