Nice UST1K, Инструкции и информация по установке и использованию

Страница: 29 / 132

EN
English – 9
SETTINGS OF THE AUTOMATIC FUNCTIONS
Automatic closing
Automatic closing is set on the S2 selector.
The closing times can be set on a value between 0 and 240 seconds.
Special function:
If there is a photoelectric barrier, the time is reduced by 5 seconds
after passage.
Time setting
0
Automatic closing disabled
1 5 seconds
2 10 seconds
3 20 seconds
4 30 seconds
5 45 seconds
6 60 seconds
7 90 seconds
8 120 seconds
9 240 seconds
5
4 6
3
7
2
8
1
90
s2 rotary
switch
Automatic adaptation to the ground
DIP 2 = ON
This function can be used if there is an SBA
sensor.
Advance notice traffic lights
DIP 3 = ON
With this function the red traffic lights
(terminals 1+2) begin to flash 3 seconds
before closing of the door.
Meaning of display messages
Upper segment:
flashing ­­> upper final position setting in progress
ON ­­> upper final position setting completed
Lower segment:
flashing ­­> lower final position setting in progress
ON­­> lower final position setting completed
movement UP, movement
DOWN,
upper final position,
preliminary limit switch
,
lower final
position.
Error 3
sensitive edge tripped, for example
In normal operating conditions, the
status of the door and/or the number
of the error present are shown on the
display.
Operation functions
In normal operating conditions, the
status of the door and/or the number
of the error present are shown on the
display. In this case position all DIP
switches on OFF!
Fault display (represented with flashing):
1 Safety circuit
2 Lower sensitive edge fault
3 Lower sensitive edge tripped
4 Lower final position not reached
(time limit)
5 Upper final position not reached
(time limit)
6 Incorrect direction of rotation of motor
7 Power during lifting deactivation
8 Door in the safety limit switch sector
9 The door is not in one of the final
positions. Correction of the final position
is impossible
0 Digital limit switch error
DIP switch functions:
DIP­1 “ON“ and 2, 3, 4 “OFF“
Setting of the final positions
DIP­1, 2, 4 “ON“ and 3 “OFF“
Precision setting of the final position (upward
movement)
DIP­1, 3, 4 “ON“ and 2 “OFF“
Precision setting of the final position
(downward movement)
WARNING:
It is possible to lengthen the duration of the waiting time of a factor
by choice (with selector in position 6 to 9) using the K5 module. The
parameter to be used is P28.
Reversed movement function
DIP 4 = ON
The door blocks and reverses its direction for
about 50 cm if the sensitive edge is enabled
during the downward movement.
DIP 4 = OFF
The door blocks and reaches the upper final
position if the sensitive edge is enabled during
the downward movement.