Nice To-Max, Инструкции по установке и использованию, предупреждения

Страница: 10 / 88

10 – English
EN
To program the limit position fitted with a mechanical system:
01. Press and hold the Up (or Down ) key to move the shutter to mid-travel.
02. Press and hold the key ( Up or Down) until the shutter stops on impact
with the limit position (“ 0 ” or “ 1 ”) then release the key.
To program the limit position without a mechanical system:
01. Press and hold the Up (or Down ) key to move the shutter to mid-way.
02. Press and hold the key ( Up or Down) to move the shutter to the required
limit position then release the key.
03. Press and hold the Up and Down keys simultaneously for at least 3 sec-
onds and release after the motor has executed a brief movement in the
opposite direction.
04. At this point activate an Up or Down manoeuvre (depending on the posi-
tion of the shutter) and immediately afterwards a manoeuvre in the oppo-
site direction to enable the control unit to memorise the two limit positions.
CAUTION! - Do not interrupt these two manoeuvres and do not dis-
connect the power supply from the automation during movement.
4. 3 – TOTAL MEMORY DELETION
CAUTION! – This procedure deletes all data from the control unit memory,
including positions “ 0 ” and “ 1 ”.
Note – If positions “0” and “1” are deleted, the main switch must be pressed
continuously (hold-to-run mode) for the entire time required to complete the
manoeuvre.
01. Press and hold the Up and Down keys simultaneously for at least 3 sec-
onds and after the motor has executed a brief movement release one key
only.
02. Within 3 seconds after the motor has executed the movement, press the
previously released key three times.
03. Then release the other key.