Installing the MNGSM module
Insert the SIM card into any telephone, verify that it is active and dis-
able the PIN code. Make sure that the control unit is powered, con-
nect the MNGSM plug-in module to the control unit then insert the
SIM card (Fig. 3). If the telephone uses a MicroSIM, use the appropri-
ate adapters available on the market (not compatible with NanoSIM).
Warning!
The SIM card’s PIN code must be disabled, together with
any messages, address books or other data present in the SIM card
memory.
Requesting information and sending commands via tele-
phone call
Warning!
Not envisaged in the EN 501316.1.1.1 standard.
It is possible to access the control unit by calling the telephone num-
ber of the SIM card inserted in the MNGSM module.
• from the telephone numbers of memorised and enabled users
• from non-memorised disabled telephone numbers (provided they
are anonymous), by digiting after the reply signal the User PIN
code followed by #
If the voice messages have been recorded correctly, the control unit
will reply with the following voice message:
System name > incoming call reply
If the voice messages have not been recorded,
wait for the acous-
tic signal.
Operations
Description
*
Ambient listening and speakerphone dialogue
0#
Verification of the control unit’s ON/OFF status (enabled/dis-
abled)
0*1#
Full enabling (confirmation reply with 3 beeps)
0*2#
Partial enabling (set for the user)
0*0#
Disabling (confirmation reply with 1 beep)
#
Interruption of alarm calls
Enter the indicated codes and wait for the reply: the control unit will
reply with the recorded voice messages or, if none are recorded, with
acoustic signals to confirm the reception of the command.
Requesting information and sending commands via SMS
Warning!
Not envisaged in the EN 501316.1.1.1 standard.
Warning!
The SMS delivery and receipt times, managed by the SIM
card provider, may cause delays in the delivery and receipt of the
sent command.
SMS
Operation
Reply / confirmation SMS
ON"OK
Verification of the control unit’s
ON/OFF status (enabled/
disabled)
ON"123456
(areas)
"OK if the
alarm is enabled OFF" OK if
the alarm is disabled
ON
Full enabling
ON"OK
ON"
123456
(areas)
Enabling in the selected areas
ON"
123456
(areas)
"OK
OFF
Disabling
OFF"OK
C?
Request for SIM card remain-
ing credit
SIM card provider reply
SMS command of actuators wired to the control unit (only for
the MNCUTC and MNCUC models)
IT is possible to activate, deactivate and request the status of each
single wired device if the name programmed in the control unit is
known:
• name of the device followed by space then ON to activate
• name of the device followed by space then OFF to activate
• name of the device followed by space then?
to verify the ON/OFF status
Data transmission activation
MNGSM is compatible with data transmission.
The server’s IP address and the APN of the providers Tim, Vodafone
and Wind are configured automatically; the user name and password
must only be entered if the provider requests them.
GSM connection
10
2
0000
00
000000
0000
3
000000
000000
0000
