Nice Apollo 72001K, Руководство по установке

Страница: 10 / 32

10
Attach the master link to one end of the chain and a chain
bolt. Then attach the chain bolt to a chain bracket. Determine
the required length of chain needed to attach the other
chain bolt and still allow adjustment. Using the proper chain
breaking tool, cut and remove the excess chain. Attach chain
to chain bolt and connect to the chain bracket.
Allow 1 inch of lag per 10 feet of chain.
Chain should be aligned with all sprockets.
10 - INCOMING POWER WIRING
Power input connections should be wired as follows:
Solar panel
Connect wires to the solar panel terminal block. The positive
wire of the panel connects to the left terminal marked “+”.
Note: If the panel is connected backwards a red LED will
illuminate below the terminal.
If solar power is to be used it
will be necessary to program control board for STANDBY
operation. See section 16 for information on STANDBY
mode.
Battery
Connect wires to the battery terminal block. The positive wire
of the battery connects to the left terminal marked “+”. Note:
If the battery is connected backwards a red LED will illuminate
below the terminal.
Main Power - This terminal block is for incoming 10-
35VDC power only!
Connect wires to the main power terminal block. Positive
of the power supply connects to the left terminal marked
“+”. Note: If supply is connected backwards a red LED will
illuminate below the terminal. If supply is connected properly a
green LED will illuminate
SOLAR
PANEL
BATTERY
MAIN
POWER
+ -
Route chain through sprockets as shown. Make sure chain is
level when attached to the chain brackets.