51
High-level elbow-joint flue connection
Stand the stove on the floor-plate. The insulation and the insulation retainer are supplied from the factory ready for rear-
flue installation. Lift off the sealing plate, insulation and insulation retainer, cut out the punched plate in the insulation
retainer and remove the centre piece of the insulation. Fit the start section of the flue (the flue-base) to the connecting
collar. Make sure that the packing round the collar is not moved from its intended position. Then replace the insulation
retainer, the insulation and the sealing plate. Secure the sealing plate in place against the stove hood by using pliers to bend
the lugs on the hood.
Install the fl ue sleeve in the wall as described in the ins-
tructions on page 48.
Adapt the length of the connecting flue pipe and slide it
into the sleeve. Seal the connection with sealing rope.
LEK
GB
