54
Installing an extension mantle
Fit the telescopic chimney mantle by lowering it into place
on the locating pins on the sealing plate. Then extend
the telescopic section up to the ceiling and secure it by
screwing it into place. Fit the rear panel into place against
the rear edges of the mantle and secure it by screwing into
the ceiling.
A coupling plate is required between two chimney mantle
sections. Place the coupling plate on the lower of the
mantles so that the threaded pins pass through the fl ange
around the top inside edge of the mantle. Fit the upper
mantle section over the pins in a similar fashion. Then fi t
rear panels to each section of the mantle.
HK
Important!
The installation must be approved by a qualified
inspector before the stove is made ready for use.
Read through the lighting and operating instructions for
the Handöl 20 series carefully before lighting the stove
for the first time.
GB
