Nibe Contura 655, Руководство по установке

Страница: 9 / 20

55
GB
Installing the surround Contura 655
Place the back of the insert on the pallet. Install
the base with the four Allen screws; screw them
into place from the inside of the legs in the base’s
securing eyelets. To facilitate installation, the screws
that secure the legs in the insert can be slackened
off. Tighten the screws after the insert has been
placed on a flat surface. Important! The heat deflector panel under the insert
must be installed in case the space is used for wood
storage. The heat deflector panel can be removed by
turning it to the left until the panel is released from
the lower screws that secure the legs in the insert.
Hook the heat deflector back onto the screws by turn-
ing to the right.
The front angle irons are installed with two crosshead
screws each. The rear angle irons are installed with
crosshead screws and nuts in the inner hole on the
firebox. Install the back panel between the mountings in the
stove using four sheet metal screws. Tap out the
knockout from the back panel at the rear connection
using a hammer. The upper screws secure the angle
iron and back panel in the rear of the stove.
655