Nibe Contura 655, Руководство по установке

Страница: 14 / 20

60
GB
Installing the oven (option)
Installing the steel heating shelf (option)
25 mm
Replace the pre-installed adjustment screw in the heating compartment with the supplied longer adjustment
screw. Position the heating shelf in the heating compartment; use the adjustment screw at the rear edge for
horizontal installation. At the side of the heating compartment there is a small gap, this is used to install the rear
cover.
Insert the cover’s protruding bent edge in the gap
on one side. Bend the cover carefully and insert the
other side in the gap so that it is level with the mantel.
When removing the heating shelf, remove the panels
in reverse order.
Remove the screw on the top hinge of the door.
Replace this screw with the threaded hexagonal pin.
This pin serves as the lower hinge for the oven door.
Screw in the screws in the upper hinge from below.
Screw them in no more than two or three turns. Hold the oven door in place on the threaded pin.
Hook the upper hinge into place and lightly tighten
one of the screws. Close the oven door and adjust it
horizontally. Then open it carefully and tighten both
screws.
Then place the back panel in the oven. If necessary,
adjust the height of the baking sheet by turning the
adjusting screw at the bottom of the oven unit.