Niagara 6600 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 38 / 44

35
Installation, Operation & Maintenance Manual M600 NIAGARA
If Unit for Program is GPM, the following message will display:
An enable to the increment key will increment the digits by one, using the cursor. An enable to the ENT key will
accept the data and position the cursor to the next digit.
When the entry for the LO Alarm is complete, an enable to the ENT key will accept the data and will jump to the next
programming parameter.
RElaY SElECTiOn
There are two configurable relay outputs. Relay 1 and Relay 2 can be configured using this parameter program.
Relay 1 can be configured as a HI Flow Alarm OR as a Bi-directional Flow Detection. Relay 2 can be configured as
a LO Flow Alarm OR as a Empty Pipe Detection.
An enable to the ENT key will display the following message:
An enable to the ENT key will continue with the configuration of the relay and will show the following display:
Relay 1 = HA Flow is the default parameter. This is the reset value for any subsequent attempt for programming
of parameters.
An enable to the ENT key will accept the selection, or an enable to the increment key will display the
following message:
An enable to the ENT key will accept the selection and will jump to the selection menu of Relay 2, or an enable to
the increment key will continue with the relay selection subroutine for Relay 1.
Relay 2 can be configured as follows:
Relay 2 = LA Flow is the default parameter. This is the reset value for any subsequent attempt for programming
of parameters.
An enable of the ENT key will accept this configuration, while an enable of the increment key will show the following
display:
Enter lO alarm
044.0 gPM
Relay Selection
?
Relay Selection
Relay 1 = ha Flow
Relay Selection
Relay 1 = BDF
Relay Selection
Relay 2 = EPD
Relay Selection
Relay 2 = la Flow