Niagara 6600 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 31 / 44

NIAGARA Installation, Operation & Maintenance Manual M600
Rev. E 28
5.0 SET-UP & PROgRaMMing
Please note that these guidelines are for software version 7.00 or higher.
nOTE 1: after applying power to the flowmeters, wait 15 minutes before entering the Programming Mode.
PROgRaMMing PROCEDURE
Two magnetically operated Hall Effect switches are provided for Data Programming. These switches are located just
below the 16x2 alphanumeric display. The left switch is the increment key and the right switch is the ENT key. Both
of the keys can be operated without opening the cover by bringing a programming magnet near the switch.
EnTERing ThE PROgRaMMing MODE
Data programming can be enabled by putting the programming magnet in front of the "E" ENT key for at least 1-2
seconds. The message will display:
Hit the ENT key. This message will display:
At this point, the cursor will be positioned to the most significant digit. A valid password entry will allow you to
continue with the Programming Mode. An invalid password entry will display:
This will then cause an exit from the Programming Mode.
FlOW MEaSUREMEnT MODE SElECTiOn
After a valid password is entered, the programming will continue with the Flow Measurement Mode Selection.
Bi-directional Mode or Uni-directional Mode can be selected. The default mode is Bi-directional Mode. You will see
this message on the display:
This is the default display. It will reset for any subsequent attempt for programming of parameters.
An enable to the ENT key will show the options in the programming. It will start with the default option of the
Bi-directional Mode. This message will display:
Enter Password
Enter Password
00
access Denied
Flow Measurement
Set BDF/UDF Mode
Flow Measurement
Bi-Directional
Default Passwords