NI TRC-8546, Начало работы

Страница: 7 / 16

The following figure shows jackscrews, zip tie mounting slots, and screw mounting
holes on the TRC-8546.
Figure 1.
TRC-8546 Mounting Features
Panel Mounting the TRC-8546
The recommended panel mounting cutout dimensions are shown below.
Figure 2.
Recommended Cutout Dimensions
The jackscrews included with the TRC-8546 work with panel thicknesses up to
2.21 mm (0.087 in.).
Caution
Tighten the jackscrews to a maximum torque of 0.56 N · m
(5.0 lb · in.).
If your panel is thicker than 2.21 mm (0.087 in.), you can mill out a recessed pocket
for the TRC-8546. The following figure shows the recommended pocket dimensions
and cutout position.
Figure 3.
Recommended Pocket Dimensions
Wiring to the TRC-8546
The TRC-8546 is used with an NI-XNET interface host port.
© National Instruments
7
TRC-8546 Getting Started