NI Climbing Frames Highlands Commercial, Инструкция по эксплуатации

Страница: 9 / 45

Tools needed:
•
Cordless drill
•
Handsaw
•
Spirit Level
•
Hammer
•
Shovel
•
Stepladder
•
Pencil
•
Measuring tape
•
10mm Hex bit
•
PZ 2 Drill Bit
Ground Preparation
1. Lay out the bases slide and 12ft swing bar in the position that you intend the climbing frame
to be placed. Ensure the bases are 2160mm apart and are parallel of any buildings, fences
etc. that you are wishing to match in with. This will give you the size of the footprint the
frame will take up in the garden.
2. Allow for at least 2m clearance beyond the end of the slide and 1.5m clearance for the other
modules.
3. Once you are happy that the layout is correct, remove the swing bar and slide.
4. Mark out clearly the centre of all 4 cut outs of each base. Once these are marked you can lift
the bases out of your way and then dig your holes.
5. If the climbing frame is on a level surface, then dig the holes at a diameter of 12” and depth
12”. The tricky part is when the surface is uneven; in this case you would have to
compensate for the slope by making some holes deeper or shallower than others (minimum
depth of 10”). The bottoms of all holes need to be level.