Nexxt Solutions NPC-T27U66B, Инструкция по эксплуатации

Страница: 6 / 11

5. The top and bottom frame subassembly is now complete.
3
Bottom tray subassembly
M8 flanged nuts (8)
Side panel stoppers (4)
M4x8mm self-tapping screws (8)
Top cover with fan tray assembly (1)
M8x12mm hexagon socket
head screw (8)
22
24
9
21
2
Top cover assembly
1. Align the frame (left side first) with the mounting holes on the top
tray. Using the M8 screws and M8 flange nuts, secure both parts
together.
Note: position the top tray with the cable entry plates pointing
towards the rear section of cabinet.
Make sure not to fully-tighten the screws until all have been installed.
2. Repeat the same procedure for the right side of the structure.
3. Locate the mounting holes of the side panel stoppers, on the right
and left sides of the structure (front and rear), as per the illustration
below.The rubber stud should be facing outwards.
4. Attach the stoppers to the frames using the supplied M4
self-tapping screws (2 per stopper).
Note:
at this time, make sure to fully tighten all the screws.
FRONT
FRONT
REAR
REAR
21
22
4
Installation of horizontal beams
1. Decide the height of the beam installation in the structure, as per
the mounting holes available in each section (top, middle and
bottom).
2. On the left frame, identify the mounting square holes, then insert
an M6 cage nut in each one, with the tabs facing outward.
Note:
make sure that both ends (front and rear) of the beam are
placed at the same level.
Top and bottom frame subassembly
Top, middle and bottom beams (4 or 6)
M6x12mm phillps-head
screw (24)
5
20
M6 cage nuts (24)
M6 plastic washers (24)
18
19
9 10
Allen wrench
26