Nexxt Solutions NPC-T27U66B, Инструкция по эксплуатации

Страница: 5 / 11

2
Frame installation to bottom tray
1. Align the frame (left side first) with the mounting holes on the
bottom tray. Using the M8 screws and M8 flange nuts, secure both
parts together.
Note: make sure not to fully tighten the screws until all have been
installed.
2. Repeat the same procedure for the right side.
Note: at this point, fully tighten all the screws to ensure proper
stability of the structure.
3. Make sure that the grounding post on the bottom frame aligns
with the grounding posts of the front and rear doors.
4. The bottom frame subassembly is now complete.
Bottom tray subassembly (1)
Frames (2)
M8x12mm hexagon socket
head screws (8)
M8 flange nuts (8)
7
4
21
22
1
Phase Required parts Steps
Bottom tray (1)
M6x12mm self-tapping screws (16 )
M4x8mm self-tapping screws (4)
Allen wrench
Caster wheels (4)
2 with brakes
2 without brakes
Leveling feet (4)
26
23
24
11
10
7
Installation of casters and feet
1. Identify the 2 caster wheels with brake mechanism and the 2
regular caster wheels which will be used in the back of the cabinet.
2. Align the two casters (with brakes) with the front mounting holes
of the bottom tray and secure them firmly using four (4) of the
supplied M6 self-tapping screws.
3. Repeat the same procedure for the remaining casters to be
placed in the rear section of the bottom tray.
4. Next, locate the mounting holes on each corner for the leveling
feet.
5. Screw the feet to the desired height, making sure all are
positioned at the same level.
Note:
make sure not to fully extend the leveling feet to the floor until
it is placed in its permanent location. Otherwise you will not be able
to roll the cabinet using the casters.
6. Proceed to install the two cable entry plates on the tray openings
from the inside using four (4) M6 self-tapping screws.
21
22
4
7
FRONT
REAR
Front door Rear door
7 8