ASSEMBLY - LA26
|
Flying Frame
Stacking LA26 on a Flying Frame
1 -
Place the flying frame on a flat surface and swivel the
four rigging arms, two on the back sides and two on the
front sides. To accomplish this task remove the lock pin,
rotate the arm and re-secure the arm in place with the lock
pin.
2 -
Bring the ground stack accessory near the indicated area
in the middle bar of the flying frame. Choose between 2º to
6º (blue circle) or 0º to -6º (green circle) by flipping the hard-
ware in order to both vertical lines to match (on the flying
frame and accessory). Insert two 10mm lock pin on the
holes signed with a white circle.
3 -
Bring an LA26 cabinet and secure it to the flying frame
starting from the front rigging arms (use the upper hole -
red circle), use one lock pin on each side on the upper hole
of the arm. Lay the enclosure down while holding the rear
rigging arm. The ground stack accessory must get into the
LA26 rear rigging slot.
4
- On the flying frame’s gound stack accessory is possible to
read the splay angle between the LA26 and the ground - its
written “Ground Stack Angle”. Choose an angle among the
possible ground stack angles (-6º, -4º, -2º, 0º, 2º, 4º, 6º) and
insert a lock pin on position 0, with “Ground Stack Pin” label,
to secure the system.
20
www.next-proaudio.com
STACKING PROCEDURE
step 1-2
step 3-4
step 2
step 2
negative angles
positive angles
step 3-4
2º to 6º Ground Stack Angles
-6º to 0º Ground Stack Angles
