ASSEMBLY - LAs15(A) | LA26 | U-Shape Bracket
for LA26
Under Balcony Application / 50mm Clamp
1 -
Secure the U-bracket to the ceiling or install the clamp on
the U-Bracket.
Remember to check the U-bracket’s orienta-
tion in order to get the desired tilt angle.
2 -
Setup the LA26 array to be installed on the U-bracket.
3 x LA26 Array - Remove the four side screws, two on each
side, from the
middle
enclosure.
2 x LA26 Array - Remove the four side screws, two on each
side, from the
bottom
enclosure.
3 -
Place the array between both U-bracket arms and, using the
provided bolts and washers, screw both parts without com-
pletely tighten them.
4 -
Adjust the tilt angle and tight the bolts.
Pole-mounting Application
1 -
Secure the Pole-mount adpater to the U-bracket using the
provided bolts and washers.
2 -
Install a M20 pole on LAs15(A) and apply the U-Bracket on
it.
3 -
Secure a LA26 to the U-Bracket using the provided bolts
and washers, do not completely tighten them.
Remember to check the U-bracket’s orientation in order to
get the desired tilt angle.
4 -
Place the second LA26
below
the pre-installed cabinet.
Start from securing the rear rigging with the lock pins and then
the front rigging with two lock pins, one on each side.
5 -
Adjust the system’s tilt angle and tight the bolts.
ATTENTION:
The maximum limit for pole-mounting is 2 x
LA26.
DO NOT USE A U-BRACKET ATTACHED TO A WALL!
17
RIGGING PROCEDURES
www.next-proaudio.com
step 1
step 1
step 3-4
step 3-4
