ASSEMBLY - LA26 | FLYING FRAME FOR LA26
1 -
Place a 4 x LA26 flight-case under the lifting point. Keep
all the inter-enclosure angles at 12º.
2 -
Remove all the safety pins from LA26 rear rigging hard-
ware.
3 -
Remove the lock pin from the rear rigging. Adjust the
swivel arm for the desired splay angle (even or odd angles)
and re-insert the lock pin at the desired splay angle. Keep
the Safety lock pins out. Do this procedure one by one.
4 -
Adjust the flying frame’s rigging shackles to meet the
best weight balance.
5 -
Secure the flying frame to the LA26, starting from the
front rigging, inserting two lock pins, one on each side.
Swivel the rear rigging arm into the flying frame’s slot and
secure it with two lock pins.
6 -
Lift the array. The inter-enclosure angles will automatical-
ly adjust to the previously settled angles.
7 -
Insert the safety lock pins on the “S” positions corre-
sponding to the splay angles (blue labelled holes).
8 -
Place another 4 x LA26 flight-case under the array. Keep
all the inter-enclosure angles at 12º (on the flight-case cabi-
nets). Lower the array until it meets the stacked one.
Do not
rest the array on the stack.
9 -
Repeat steps 2 and 3.
10 -
Connect the array to the stack starting from the front
rigging. Insert two lock pins, one on each side. Swivel the
rear rigging arm into the last array speaker and insert the
lock pin. Keep the safety lock pin out.
11 -
Lift the entire system and insert the safety pins on the
last enclosures.
ATTENTION:
This method can only be used up to 8 LA26.
For bigger arrays, the enclosures must be connected one by
one.
14
www.next-proaudio.com
RIGGING PROCEDURES
H
step 1-2
step 3
step 5
step 6-7
